Power Equipment Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
8 Posts
Discussion Starter #1
Hello All..

I finally got my GenTran 300660 PowerStay transfer switch hooked up, and today I got to testing the generator setup on the switch.

I have two Yamaha EF2000is Generators connected w/ the Twin Tech cable.
This setup gives me a rated 25 amps of power, and peak 30 amps.

I ran almost everything I wanted to with no issues.

I had approximately 200 watts of lights bulbs (led/cfl's)
1 LG Refrigerator
1 Entertainment System (Led TV, Tivo, Surround System) (appx 150 watts)
Nat Gas Furnace (smaller 2 tons sized unit)
Nat Gas Tankless (instant on) Hot Water Heater appx (50 watts)
Security Alarm / Home Networking (router / verizon fios system) (appx 100 watts)

If I turned the furnace off (leaving the rest of the above on) I could also run the following...

A hair dryer
A 1100 Watt Microwave
(Not at the same time of course)

I also plan on having my father-in-law fabricate a custom wood cover for the main panel and transfer switch, he has saw dust running through his veins.

I plan on putting together a You Tube video of this setup, as I couldn't find one before I did this.
 

Attachments

·
Registered
Joined
·
8 Posts
Discussion Starter #2
Well.... I finally put together a YouTube of my setup. From the lack of replies, i'm not sure anyone here may be interested, but here is the link incase you are.

 
1 - 3 of 3 Posts
Top