Power Equipment Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
24 Posts
Discussion Starter · #1 ·
Walbro primerless carb . Can anyone tell me the factory carb settings for the 3 screws ? Right now I'm at 2 turns on top two screws . With the help of starter fluid it will start , idle for a few seconds and die . Routed new fuel lines and gas is getting to the carb .
 

·
Registered
Joined
·
9 Posts
Walbro primerless carb . Can anyone tell me the factory carb settings for the 3 screws ? Right now I'm at 2 turns on top two screws . With the help of starter fluid it will start , idle for a few seconds and die . Routed new fuel lines and gas is getting to the carb .
Just set mine today at 7/8 for L and 3/4 for H.1100 feet above sea level and 75 degrees.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top