Power Equipment Forum banner

1 - 1 of 1 Posts

·
Registered
Joined
·
29 Posts
Discussion Starter #1 (Edited)
I have to replace rings on Redmax trimmer and after I line rings up with pin on piston I then slip it over the cylinder while holding both rings in. I replaced cylinder piston and rings and after we get rings in cylinder one of them turns slightly when both rings are in the cylinder so we remove the cylinder and try it again. Is there a easier way to compress them while they are lined up to each pin with out them turning?
 
1 - 1 of 1 Posts
Top