Power Equipment Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
Hi,

I have a Husqvarna 335 FR Brush Cutter, and as a result of heavy use, the power head has twisted on the shaft about 15-20 degrees.

Is anyone familiar with how the powerhead is mounted to the shaft?

Is it just a friction fit, that I can loosen, reposition, retighten, and keep going?

It also started to make an ocasional clunking noise- coming from either the top of the shaft, or the power head- while cutting ~3ft grass and weeds- any ideas on this?

Thanks:confused:
 

·
Premium Member
Joined
·
611 Posts
there may be a screw near the hand grip just in front of the engine if there is that is what holds the shaft in place should be able to loosen that and then turn it where it needs to be and retighten the screw
 
1 - 2 of 2 Posts
Top