Power Equipment Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
I need help with a Poulan P3416 Clutch Brake install. When I took it apart a small roll pin fell out and I can't see where it goes. It is not the roll pin in the center of the brake handle. I then tried to put the new clutch brake in as shown on the web, however the handle will not move at all to release the brake. The clutch brake goes in fine, but something must not be in alignment not allowing the handle to move backwards to disengage the brake in order to put the clutch cover back on. The pin is about an 1/8" x 1" long that fell out. I appreciate any help you can give me.
Thanks,
PhilG
 
1 - 2 of 2 Posts
Top