Power Equipment Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter · #1 ·
Greetings all!

I'm looking for some help on my genset. Some of the wiring harness melted and I reached out to Wrico who wanted $875 for a replacement harness and was unwilling to provide a diagram. I'm definitely not going to fork out that much money to replace a charred wire and get no diagram in return. Beware of Wrico International - they don't seem willing to support their own product without gouging their customers.

What I'm looking for is help identifying the wiring and doing some basic testing so I can get a generic remote start controller hooked up.

Very willing to compensate someone to help me get this figured out and running again.
Thanks!
Shaun
406-480-6373
9179


9180
 

Attachments

·
Registered
Joined
·
2,551 Posts
so what are your skills?
are you in to diesel? maybe basic wiring?

not too much to the wiring on this unit pretty basic diesel stuff.
 

·
Registered
Joined
·
3 Posts
Discussion Starter · #3 ·
so what are your skills?
are you in to diesel? maybe basic wiring?

not too much to the wiring on this unit pretty basic diesel stuff.
I replaced a good portion of the wiring and it fired up. There is a static voltage regulator I'm not sure how that works. I'll post a picture of it.
 

·
Registered
Joined
·
3 Posts
Discussion Starter · #4 ·
Here is a picture of the Static Voltage Regulator

9185


Here is a picture of the specs on the generator portion. I put a multimeter on the lines and it was producing 155~ volts

9186
 
1 - 4 of 4 Posts
Top