Power Equipment Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter #1
I inherited a Kipor 2000 generator about three years ago. Anyway, I plugged in an appliance I think was 1500 watts. The engine ran fast for a bit with the smart throttle switch on and then back to slow and there was no electricity. The next day I tried it again and it produced electricity until I plugged in the same appliance. Since then it never produced any more electricity. The green light indicates it is producing electricity. I took off the panel where the recepticles are and there is no electricity coming from the wires attached to the recepticles. I do not see any fuze or circuit breakers anywhere. What is my next step to diagnose the problem?
 

·
Premium Member
Joined
·
347 Posts
there has got to be a breaker/fuse somewhere on the unit, look very hard it may look like a light switch
 

·
Registered
Joined
·
4 Posts
if you have a genset not making power unplug the genorater and check the windings with an ohms Meter see if the windings are open if so your gensets no good
 
1 - 3 of 3 Posts
Top