Power Equipment Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
Made the mistake of loaning PW to relative. First, it bounced to the edge of his deck and dropped a foot or so to the ground, landing on it's side. Continued to run until he saw it belching smoke, then shut it down. When I got it back, I cleaned carb and air cleaner box of oil and re-assembled it. Now, it will start and run fine, but when I pull the trigger to start pressure, the motor bogs and while it puts out pressure, it is greatly reduced because the engine is running much slower. I suspect that something in the carb linkage did not go back together correctly, causing the engine to bog when a load is applied, but can't find any clear diagrams on line showing the proper way to fit everything. Anything obvious I'm missing?
Thanks!
DFS
 
1 - 1 of 1 Posts
Top