Power Equipment Forum banner
1 - 7 of 7 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter · #1 ·
First I change oil and oil filter engine is perkins, and the alarm show again ( low oil pressure), I didn't know where is the problem in the screen controller ( comap screen) or in the pressure sensor. The sensor comes with two pin, 1 pin I measure the volts it was (2.5 volts) comes from screen (comap) my generator is visa generator 20 kva. Need help. You can find sensor in the photo
Finger Wood Gas Cable Wrist
 

·
Registered
Joined
·
3,815 Posts
what are the hours on the gen set?
snap some pix of the model number and serial number tags on the gen set.
 

·
Registered
Joined
·
3,815 Posts
start with an oil pressure gauge and see what the real pressure is on the motor.
 
1 - 7 of 7 Posts
Top