Power Equipment Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
My wife was using our power washer and she dropped it down a step, causing it to smoke wildly. Now it will not start. Does anyone have any suggestions on what I can do. You can put me onto some video help if you like, Thanks in advance.
 

·
Premium Member
Joined
·
611 Posts
I would start by removing the spark plug and pulling the rope a few times to clear the oil out of the cylinder then inspect everything very thoroughly to make sure that there are no cracks or damage to the pump and motor on the outside then check and top off the oil and fire it up make sure everything is working correctly and use it for a bit that should allow any residual oil to be burned off from inside the cylinder and the smoking to stop
 
1 - 2 of 2 Posts
Top