Power Equipment Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
9 Posts
Discussion Starter #1
I replace the carb on my generac xp8000e In doing so I removed the governer lever and now can't get it to idle right. Is there an easy way to re-assemble the lever ans set the governer
 

·
Registered
Joined
·
163 Posts
The best I can tell you to do is to contact Generac and see if they can provide you with a service manual. I believe you can find Generacs 800 number with a Google search. Roger
 

·
Registered
Joined
·
380 Posts
Again I'd suggest you take it to someone that knows what they are doing.
If you still want to pursue trying it yourself, I'll see if I can walk you threw it.
Have you removed the bell crank lever with the holes and connector rod from the shaft that is going threw the crankcase? Do you remember which hole the connector was in? Do you still have the spring and recall it's correct location?
Do you know of another engine you can look at and photograph?
 

·
Registered
Joined
·
9 Posts
Discussion Starter #4
Thanks for the advice, I took it to the local Generac service person to reset the governor. we got hit with the snow so I'm not sure when it'll be ready.
 
1 - 5 of 5 Posts
Top