Power Equipment Forum banner
1 - 8 of 8 Posts

·
Registered
Joined
·
4 Posts
Discussion Starter · #1 ·
Font Gas Motor vehicle Metal Number

Cześć wszystkim, zamierzam zbudować agregat prądotwórczy w oparciu o generator Leroy Somer, zdjęcia poniżej i silnik disla 1.9 td.
problem w tym silniku z rozrusznikiem montowany jest od alternatora a nie silnika alternator nie ma łożyska z przodu i nie wiem jak go podłączyć
Water Automotive tire Manhole cover Gas Circle
 

·
Registered
Joined
·
115 Posts
Polish/English translation
Hi everyone, I'm going to build a generator based on a Leroy Somer generator, photos below and a 1.9 td disla engine.
the problem in this engine with a starter is mounted from the alternator, not the engine, the alternator has no bearing in the front and I do not know how to connect it
 

·
Registered
Joined
·
1,171 Posts
Boy, @Krypton, there's a lot of torque you're trying to pass through those threaded rods. I'm betting on catastrophic failure... Or maybe you'll just make a big metal pretzel? Or at least a helix.

You may want to consider a rubber transmission coupling.
 
  • Haha
Reactions: iowagold
1 - 8 of 8 Posts
Top