Power Equipment Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
Hello,
I am having a problem with my old DeVilbiss GT5000 generator. It has no output voltage. I just used it through Sally and worked OK. So I was giving a good tune-up/ oil change... to put away for the next use.

After getting the Engine to run great. I checked the output voltage and nothing... I open it up and everthing looks great. I checked the Cap with my meter and it looks good. The cap reads 35.5 uf and it's a 35uf cap.

I buss it out with my meter and looks good to me. I have read on the internet about reflashed it. But not sure how to do this. Can someone help?
Thanks Stu
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top