I have a Devilbiss GB5000 generator, and need a wheel kit for it. Porter Cable bought them out, and it does not appear that the wheel kits are offered any longer, but I know that someone, somewhere, still has a few of these wheel kits. I really don't want to build this stuff. Anyone know where I might find what I need? Thanks!
Devilbiss GB5000 generator wheel kit
Join the discussion
Recommended Reading
-
Generator ForumI was browsing some mid-range generators looking to see what features some have on the market and came across this DuroMax unit. 3850w running 4850w starting gasoline and propane electric start switchable voltage - 120v only (higher amperage) or dual 120/240 on the L14-30 twist-lock That is a...
- 0
- 14
-
Generator ForumAll, I got the parts set up for my old rotary generator to run it on propane but I'm having issues with it. I can't get the engine to fire. A few details - The gas manifold sits under the carb. The regulator is a Garretson KN style The propane hose from the tank (using a bit thats left in a...
- 7
- 91
-
Generator ForumI got my GX690 powered 15kw unit running on propane today. I didn't run it long, just test fired it. I will do some more with it tomorrow - on natural gas also. After wearing the skin off a few fingers pulling the cord start on my smaller unit trying to get it to run on propane the electric...
- 0
- 28
-
Generator ForumGuys i don't have natural gas but desire to run the E2200 on propane primarily, and gasoline when out of propane. Which kit would you use?
- 3
- 102
-
Ground Fault · updated
-
Generator ForumI am looking at putting a standard 1" iron pipe through a concrete block wall for a cable pass-through. The pipe is 1" ID and 1.320" OD. Does anyone know if a 1-1/4" bit for a rotary hammer will work - maybe with wollering out the hole a bit to get the pipe through? Or will the hole left by a...
- 14
- 273
Join now to ask and comment!