Power Equipment Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter · #1 ·
Hello

I have a pressure washer with a hose with 14,8 mm inner tube and a 22mm outher scew connection.
I have bought a long lance for it but the only one that was available was one that requires a 14 mm inner tube. So 14,8 mm will not fit.
I wonder if I get a new hose with 14 mm inner tube to fit the lance, will that be a leakage problem in the connection to the pressure washer since the hole is for a 14.8 mm tube, or can I solve that with a rubber gasket ?

Anyone that has an experience to share ??

Regards Petter
 

·
Registered
Joined
·
3 Posts
Discussion Starter · #3 ·
Can you get an adaptor ?
I have tried but so far I have not been able to find any.
Most of the pressure washers has 14,8 mm inner tube. There is one washer that will fit. Its a Kärzle but that washer is about 3 times as expensive than those for normal households .
 

·
Registered
Joined
·
3 Posts
Discussion Starter · #4 ·
Can you get an adaptor ?
The picture here shows the adapter that sits on the lance.
Number 1 goes into the lance and is about 16 mm in diameter
Number 2 goes onto the hose and is 22 mm but has a hole at 14 mm
So if I could replace this one with an adapter with 14.8 mm hole I would be good to go.

Gesture Household hardware Wood Currency Cylinder
 
1 - 4 of 4 Posts
Top