Power Equipment Forum banner

Change a pull starter to key or push start?

3440 Views 4 Replies 4 Participants Last post by  RonJ
I want to know how to start the Generator without pop my arm out of place. it is a Powerpro 4050 watt and when it off to long it's hard to start even for me

and there is a problem with the choke. the generator only runs if the choke is left on. i shut the choke off and it dies. We use the Generator to power the house were liveing in tv,light,fans,small college frizge it be work real good the only problem have be the choke and if you guys know any tricks to make the it run longer on tanks gas
1 - 5 of 5 Posts
Some engines will accept an electric starter.
Starting fluid should make it easier to fire up.
If it only runs with the choke on, then the carburator probably will need to be disassembled and cleaned of gummed up gas.
An extra tank would be needed for longer run times.
it was brend new with the choke problem should i just call in and see if they send
a replace Generator and thanks for help
PowerPro Problem

You asked about doing something so you wouldn't have to pull the rope; I recommend you check out U-Tube for gas engines started with a drill, might help. Ron
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top