Well, I just received and installed the US Carburetion tri-fuel kit and everything works great! I had a spare 1/2" natural gas line that was originally used for a fireplace insert, removed and capped a few years ago. I added a quick disconnect to this line and ran a 12 ft hose to the...

I've got 1800 hrs on the genset at this point. I use it as our backup in an off grid Outback Power setup to charge our batteries in low light so it primarily only runs in the winter. I may also run in high load situations which is about never. It is tied to the the OB stuff with an Automatic...

Think this will work? Honda eu2200i powering Northern tool air compressor Honda eu2000i powering cheap plasma cutter Links below if they work I think the air compressor draws 15 amps...

A friend just dropped off a Karcher G2600 VH pressure washer with a Honda GCV160 engine. The unit is dripping oil. The oil is clean and clear, like fresh oil. He said that it never lost pressure at all. He noticed a film on the driveway when he was pressure washing it, and realized that it...

Hi all. New here. I have a Chinese 5kVA open-frame generator with a GX390 clone engine. I just replaced the carb with a tri-fuel replacement and it runs fine on gasoline. But when I switched to propane/LPG, it ran a little rough at first. I loosened the fuel screw (yellow arrow in the pic...